
Built to fit the repair
Field & Custom Steel Fabrication
Plates, gussets, brackets, mounts, guards and replacement members fabricated to fit the repair or project, built on site or prepared ahead and installed by AHT.
Some repairs and projects need new steel. AHT fabricates the replacement members, reinforcement, mounts and guarding the job calls for, cut and fitted on site or prepared ahead and delivered ready to install.
Fabrication is scoped as part of each repair or project, so the part fits the machine or structure it is going on.
Every fabricated part is welded to the same written procedures as the repair it supports, so the new steel is never the weak point.
What AHT handles
- Reinforcement plates, gussets and doublers
- Brackets, mounts and tabs
- Base plates and mast mounts
- Replacement structural members
- Guards, rails and access steel for equipment
- Chute, hopper and liner plate replacement
- Modification to fit new attachments or loads
- Fit-up and installation on site
Measured where it goes, built to fit
A part built from a guess gets cut and refit on site. AHT measures the existing steel, the mounting points and the clearances before cutting, and checks fit against the machine or structure before final welding.
Where a part is better built ahead, it is prepared from field measurements, drawings or a sample part and arrives ready to install. Time on site stays short and so does the downtime.
When fabrication is part of the job
Fabrication at AHT is scoped as part of a repair or project: replacement members for a damaged frame, reinforcement for a joint that keeps failing, mounts for new equipment, or guarding and access steel on plant equipment. Each part is listed in the written scope with the work it supports.
Materials and methods
- Plate, flat bar, angle, channel and tube in carbon steel
- Wear plate for liners and high-abrasion parts
- Cutting, drilling and fit-up on site from the mobile rig
- Stick (SMAW) and flux-cored (FCAW) welding to AWS D1.1 under written procedures
- Photo documentation and a written closeout for every job
In the field



Can parts be fabricated to fit on site?
Yes. Brackets, plates, gussets and replacement components are measured, cut and fitted where the equipment sits, so the part matches the machine.
Does AHT fabricate from drawings?
Yes. Drawings, sketches or a sample part all work. Where a part carries load, the repair is scoped in writing before fabrication starts.
What does AHT need to quote fabrication?
Photos of the location, rough dimensions or a drawing, and what the part has to carry or resist. A sample part works as well. AHT confirms measurements on site before final fabrication.
Are fabrication welds made to a procedure?
Yes. Fabrication welds are made to AWS D1.1 under written welding procedure specifications, the same standard as AHT repair welds.
Related
Related services.

Structural Welding & Repair
Crack repair, reinforcement and weld restoration on frames, attachments and fabricated steel assemblies.
Learn more
On-Site Cutting & Gouging
Torch cutting and carbon arc gouging to remove failed welds and prepare joints.
Learn more
Trailer & Truck Frame Repair
Cracked I-beams, crossmembers, spring hangers and underride guards repaired on site.
Learn moreRequest service
Steel to fabricate for a repair?
Call AHT or send photos. The repair is scoped in writing before any work starts.